While we understand that the RRAMC controller on the nRF54L15 performs writes to RRAM using full wordlines, the datasheet indicates that the nRF54L15 RRAMC supports writes...
Subject: nRF9151 – EU coverage of mfw 2.0.2 and antenna gain (Schréder Sense One)
Dear Nordic
I'm working on CE and RCM certification for Schréder's SENSE ONE smart-city...
We have an nRF54L15 (QFAA) board, acting as an I2C target ( TWIS30, P0.00/P0.01, address 0x42, 100 kHz ) for an ESP32-S3 through a TCA9406 level translator.
Flow:
Between...
Hello, I am requesting a schematic review of my bluetooth microphone system. I've used the spec sheets as well as audio DK hardware reference material to design these schematics...
We are seeing very high defect rate when installing this part on boards: insufficient solder, solder bridging. When we look at the pads under the microscope, we are seeing...
Hi,
I attached here some slides that we used in our technical seminar for Device Firmware Update.
Download the presentation here: DFU_SDKv8.0_Pub.pdf
The presentation covers:
What DFU is and what…
Wireshark (version 1.12.5 at the time of writting) lists MQTT as supported protocol but could not parse it from the TCP payload by default. We can add some plugins to enable it.
Download the Wireshark…
The RADVD deamon in Raspberry pool is version 1.8.5 (up to Raspberry 2015-02-16).
root@raspberrypi:~/radvd# apt-cache policy radvd
radvd:
Installed: 1:1.8.5-1
Candidate: 1:1.8.5-1
Version table…
In SDK v8.1 we added the TWI driver (nrf_drv_twi.c). Unfortunately the nrf_drv_config.h file wasn't updated correctly with the new driver.
The symptom is the error with "TWI_COUNT is missing".
Here…
If you are looking for a place to get started with DFU, please have a look at this presentation here and the tutorial here.
In this post, we cover some in depth Q&A topics regarding Device Firmware…
One way to program the nRF51822
Bluetooth Smart Beacon Kit is to use
the nRF51 DK. This gives you a full
scale development platform (the nRF51
DK). This blog will go thru the steps needed to program…