Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
The finer points of PWM on nRF52 using two chained buffers 0

I'm looking into a rare issue on the BBC micro:bit V2 which uses the nRF52833 as its (application) microcontroller. I used to be familiar with some CPUs from the 80s but my...
- pwm
- nRF52833
- hardware
- Pre-production
10 views

0 replies

Started 26 minutes ago
by kevinjwalters
Not Answered
Subject: Cannot use GPIO P0.19 on nRF9160 as UART TX pin 0

Hi everyone, I'm working with the nRF9160 and trying to configure P0.19 as the UART TX pin using Zephyr. Here's the configuration I used in the device tree: uart1_default...
22 views

0 replies

Started 2 hours ago
by thwcs7
Not Answered
Do o need ble bootloader separately 0

I have shifted from silicon labs for BLE project. In Si labs we have burn BLE bootloader and BLE application separately. Do i need to do the same here in nrf controller? If...
16 views

0 replies

Started 3 hours ago
by Subham
Not Answered
Find My Get Serial Number Self certification test case failing 0

Hello, I am using nRF Connect SDK v3.0.1, together with the Find My add-on. Test case TCG013 of the Find My Network Self-Certification Test Cases R1.7 is failing on the...
19 views

0 replies

Started 3 hours ago
by maelclerambault
Not Answered
I2C devices are not getting detected in NRF54L15 Dev Kit. 0

I am unable to detect any i2c device when connected to the Nordic nRF54L15 DK kit. I have change the voltage from 1.8v to 3.3v and Tried and explore other pins in Port 0 and...
- software
- beginner
- nRF Connect SDK
- debugging
- nRF54L05
- Evaluation
- Protocol
- nRF54L15
- documentation
- zephyr
- twi
17 views

0 replies

Started 3 hours ago
by rsramki

Recent in Nordic blog

Compatibility between DFU bootloader and DFU master

Hung Bui

We have been receiving quite a few questions about the compatibility issue between the bootloaders from different SDK versions and the DFU master such as nRF Master Control Panel, nRFToolbox, etc. In…
- 10 Jun 2015
"OpenWRT Series" #1: setting up TP-Link WDR4300 (or N750) for Bluetooth Low Energy 6LoWPAN

PK

The first version of Nordic IoT SDK has been released over 6 months. Till now, there have been no well-known router solutions supporting Bluetooth Low Energy over IPv6. This made us the BLE application…
- 10 Jun 2015
The S110 7.3

Asbjørn Sæbø

We are now releasing the S110 7.3 (s110_nrf51822_7.3.0). This is a new production release in the S110 7.x series. (It will be uploaded today or early next week.) This is a bugfix release - as the release…
- 5 Jun 2015
A presentation on how nRF51 DFU works

Hung Bui

Hi, I attached here some slides that we used in our technical seminar for Device Firmware Update. Download the presentation here: DFU_SDKv8.0_Pub.pdf The presentation covers: What DFU is and what…
- 4 Jun 2015
Parse MQTT message in Wireshark for IoT test

Jun Qing ZOU

Wireshark (version 1.12.5 at the time of writting) lists MQTT as supported protocol but could not parse it from the TCP payload by default. We can add some plugins to enable it. Download the Wireshark…
- 26 May 2015
Upgrade RADVD for IoT on Raspberry Pi 2

Jun Qing ZOU

The RADVD deamon in Raspberry pool is version 1.8.5 (up to Raspberry 2015-02-16). root@raspberrypi:~/radvd# apt-cache policy radvd radvd: Installed: 1:1.8.5-1 Candidate: 1:1.8.5-1 Version table…
- 25 May 2015