Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Sharp memory LCD library 0

Hi, Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51? Could you please advise on how to convert this Arduino...
- lcd library
1526 views

0 replies

Started over 9 years ago
by LK13131
Not Answered
Some questions/maximum ratings for nRF52 ADC device 0

Hi all, I have a few questions: How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc... The datasheet has "typical...
- nrf52 adc noise maximum rating
1125 views

0 replies

Started over 9 years ago
by Therm
Not Answered

nrf51 pca10028 and Android 5.1 throughput 0

Hi all ! I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central. To do...

1615 views

0 replies

Started over 9 years ago
by T_chapelle
Not Answered

About I2S data acquisition and processing 0

I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...

1482 views

0 replies

Started over 9 years ago
by TOM123
Not Answered

A challenging Problem - directed broadcast! 0

static void on_adv_evt(ble_adv_evt_t ble_adv_evt) { uint32_t err_code; switch (ble_adv_evt) { case BLE_ADV_EVT_FAST: err_code = bsp_indication_set(BSP_INDICATE_ADVERTISING...

962 views

0 replies

Started over 9 years ago
by Sriun

Recent in the DevZone Blog

Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015
nRF51 Qt GCC Example

Jacob Portukalian

Hi Everyone! At Sky Wave Design, we recently switched all of our Nordic development over to using GCC and using Qt Creator as the IDE. We have released our example project on github for those of you…
- 31 Jul 2015