Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
nRF93M1: plans to expose LTE Timing Advance through the AT command interface? 0

Hello Nordic Support, I am developing a cellular positioning solution using an nRF93M1 LTE Cat 1 bis module. I currently use the following command to retrieve the serving...
9 views

0 replies

Started 26 minutes ago
by ing-barbiz
Not Answered
Request for RF Tuning Support – nRF54LM20 with nRF21540 FEM 0

Hi, We are experiencing a low RSSI/range issue with our nRF54LM20 module using the nRF21540 FEM. We have already consulted with you regarding the design under Case ID...
64 views

0 replies

Started 1 day ago
by Irfan Memon
Not Answered
Achieving pin retention in nRF54L15 GPIO without hardware pull-up through sys_reboot() 0

Hi, I have encountered a challenge with the nRF54L15 that I am hoping someone might know a solution for! My device has a power enable pin (on GPIO1) that must ideally...
102 views

0 replies

Started 2 days ago
by htownclyde
Not Answered
NRF_MODEM_LIB_MEM_DIAG_ALLOC Kconfig setting needs log but increments the failed allocs (which is not only used for logging statistics but for diagnosis as well). 0

I am using the SDK v3.4.0 LTS for modem error debugging I included: prj.conf I am mapping errors depending on wether memory allocations failed. I am fetching the stats...
86 views

0 replies

Started 2 days ago
by Peter Horauer
Not Answered
An aborted Channel Sounding procedure leaves ~1 mA residual current until reset (SDC 200.12506) 0

If a Channel Sounding procedure is aborted while in flight and the ACL is then disconnected, the device settles at a flat ~1 mA with the CPU asleep in the idle thread and...
111 views

0 replies

Started 3 days ago
by Nat E

Recent in the DevZone Blog

SkyenLab initial hardware design

SkyenLab

PCB Design Abstract: The SkyenLab Bluetooth module was developed using the nrf51422 QFN48 QFAC reference design as well as help from the Nordic Semiconductor support portal and white papers. A proof…
- 5 Apr 2016
SkyenLab scope and product development - Part 1

SkyenLab

Our Project This post is to clarify team SkyenLab’s scope for satisfying the senior design class requirements and Nordic Semiconductor requirements during the first semester (Aug. 2015 - Dec. 2015) of…
- 5 Apr 2016
You will never guess how JLink deals with UART flow control

Eirik Midttun

TL;DR: It ignores whatever the computer tells it to do and does an automatic detection. And the reason? UART terminals are not doing flow control settings in a consistent way, and in some cases incorrectly…
- 29 Mar 2016
.NET Micro Framework driver for the nRF8001

Bob Louwe

Introduction A few months ago I started running again. Music helps me to stay motivated. Since most earphones keep falling out, especially when the sweat comes out, I googled for some sports earphones…
- 21 Mar 2016
Migration from µESB to nrf_esb

Rune Holmgren

List of changes from µESB to nrf_esb All functions, structs, enums and defines have been renamed from uesb_xxx to nrf_esb_xxx. Events: Events used to be triggered within radio interrupt context…
- 18 Mar 2016
Deprecating support for CMSIS Pack in nRF5 SDK

Pär H

Some news I wanted to highlight from the SDK team. What With the release of nRF51 SDK v7.0.1 in Oct 2014, we introduced support for CMSIS pack. The main motivation was to have an easy to use dependency…
- 17 Mar 2016