Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered

IPV6 mesaages in implementation of iot sdk 0

After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...

706 views

0 replies

Started over 11 years ago
by FormerMember
Not Answered
nRF8001 SDK needed! 0

Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code. I don't have any registration key, how do I get hold of it? ...
- nrf8001 sdk
672 views

0 replies

Started over 11 years ago
by Silvere Letellier
Not Answered
Bricked my brand new nRF51-DK? 0

Hi, I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
- nrf51-dk
911 views

0 replies

Started over 11 years ago
by David
Not Answered

master slave, link 0

Hello, I would like to do an communication between Arduino and Android platform. In my case, Android will be master. But I want also test between 2 Arduino with an Bluetooth...

692 views

0 replies

Started over 11 years ago
by Vorms
Not Answered

How to write and read long characteristics in central S120? 0

I want to read and write long string in central side how it possible? Regards, Himansu

1046 views

0 replies

Started over 11 years ago
by Himansu Donga

Recent in the DevZone Blog

Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015
nRF51 Qt GCC Example

Jacob Portukalian

Hi Everyone! At Sky Wave Design, we recently switched all of our Nordic development over to using GCC and using Qt Creator as the IDE. We have released our example project on github for those of you…
- 31 Jul 2015