Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
pin_change_int example 0

void in_pin_handler (nrf_drv_gpiote_pin_t pin, nrf_gpiote_polarity_t action) { nrf_drv_gpiote_out_toggle(PIN_OUT); } This function work with interupt event (push...
1896 views

0 replies

Started over 9 years ago
by Stas
Not Answered

need help about multilink Demo 0

here I have a very strange problem. I m trying to send the data(1 byte) from slave to master,and I have to use the multilink demo because I will have 2 slave devices. The...

639 views

0 replies

Started over 9 years ago
by mada
Not Answered
fds FRESH_INSTALL, desired functionality. Attempt to build unsuccessful 0

I'd like to erase all the pages managed by FDS as part of a "Hard Reset" operation. fds.c has a hint of a "FRESH_INSTALL" directive (part of an enum defined in fds_internal_defs...
- fds keil stack flash
855 views

0 replies

Started over 9 years ago
by dav lion
Not Answered

device_manager_evt_handler return error 0x88 0

nrf51822 SDK v10 SD S110 v8 hello! My pj is about ANCS+nus+hid mouse sevices. If my borad had bonded with an iPhone,then download new hex from mdk ,and run. ...

717 views

0 replies

Started over 9 years ago
by qinhao
Not Answered

segger jlink cortex m4f floating point debugging 0

Hello. I would like to develop FW for the nRF52832, using Eclipse IDE + ARM GCC + Segger JLink OB. I've seen on the segger webpage that the nRF52832 is a Cortex M4 processor...

955 views

0 replies

Started over 9 years ago
by kobyfr

Recent in the DevZone Blog

Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015
nRF51 Qt GCC Example

Jacob Portukalian

Hi Everyone! At Sky Wave Design, we recently switched all of our Nordic development over to using GCC and using Qt Creator as the IDE. We have released our example project on github for those of you…
- 31 Jul 2015