Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Matter door lock using Bluetooth LE with Nordic UART Service 0

I am try to make Bluetooth LE with Nordic UART Service bondable in to pair with central, not requiring to enter pairing code again and again. I have set followings in prj...
12 views

0 replies

Started 2 hours ago
by BilalAliAhmad
Not Answered
FOTA for nrf52 based hci controller 0

Hi, I am using nrf52840 to run as an hci controller over UART for nrf91. I was able to implement FOTA over BLE for nrf91, but I would also like to add an option to add FOTA...
15 views

0 replies

Started 4 hours ago
by Michal
Not Answered
lte_ble_gateway no prints and unrecognized USB 0

Hello, After a lot of struggle i was finally made it to the point i can build and flash to my thingy 91 the lte_ble_gateway. However, i added prints (printk) in main.c to...
18 views

0 replies

Started 9 hours ago
by Raz_k
Not Answered
Partitions section in Memory Report tool is disappeared 0

Hi everybody I'm using nRF Connect SDK 2.6.1. Before I could seen Partitions section in Memory Report tool, but now it's disappeared. I also checked it by ninja command: ...
- development
- nRF Connect SDK
- debugging
- Evaluation
- ROM
- configuration
- zephyr
- ram
- nrf52840
- Pre-production
21 views

0 replies

Started 11 hours ago
by master.chipset
Not Answered
Bluetooth LE RX current comsumption for nRF54L15-DK is higher. 0

I work samples/bluetooth/scan_adv on nRF54L15-DK. Disable LOG and CONSOLE. I measured current comsumption by PPK2. Result is about 4mA. On datasheet, nRF54L15's Bluetooth...
25 views

0 replies

Started 13 hours ago
by loquat

Recent in Nordic blog

Using the ADC with the S110 SoftDevice

Stefan Birnir Sverrisson

A good place to start with getting to know how to use the ADC with the S110 SoftDevice is by using one of the BLE ADC code examples provided on Nordic's Github page, where BLE examples have the "ble_…
- 28 Nov 2014
Nordic sponsoring hackathons

Eirik Midttun

Right before Web Summit - the "Davos for Geeks" - Nordic Semiconductor sponsored its second Hackathon in Dublin: the Hardware Hackathon. As a sponsor Nordic provides hardware and mentors for…
- 21 Nov 2014
Nordic beacons and iOS

Asbjørn

The beacon market is going in various directions with regard to format and limitations, but the nRF51822 can support all the various BLE based beacons as it’s just a specific type of non-connectable BLE…
- 18 Nov 2014

Latest guides

Software and Protocols: Automating nRF91 TLS credential management via serial port AT commands

Daniel Veilleux

I have spent a bit of time recently experimenting with different TLS credential configurations using nRF91-DKs. Eventually I got to the point where I wanted to do things like swap out the certificates…
- 10 Jan 2020
Getting started: nRF Connect for Cloud Certificate Update

Joakim

The content of this guide is now covered in the documentation on nrf Connect SDK documentation page.For the most up-to-date instruction to Update Cloud Certificate please follow this link.
- 27 Sep 2019
Getting started: Thingy:91 Firmware Update using MCUboot

Joakim

The nRF Connect Programmer application now also supports MCUboot! Follow these steps to update through the programmer application or the following guide for the command line alternative. This guide shows…
- 23 Sep 2019
Bluetooth low energy: Concurrent Advertising

Håvard

I have been asked several times about variations of the following advertising scenario, so I decided to make a blog post that I can refer to, and hope it might prove useful for others out there that are…
- 9 Sep 2019
Software and Protocols: The four kinds of data you need to consider when developing an IoT product

Markus Tacker (he/him)

In this post I will give you an introduction to the four kinds of data you need to consider when developing an IoT product: Device State Device Configuration Past Data Firmware Updates It's these …
- 9 Sep 2019
Getting Started : Automate building of HEX files for your nRF Connect SDK application using CircleCI or GitHub Actions

Markus Tacker (he/him)

Continuous delivery is in important aspect of short time to market and since the nRF9160 supports firmware over the air updates we want to ship a new firmware to our development boards every time we update…
- 14 Aug 2019