Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
PAwR response delayed by one periodic interval 0

Hello, We are using 2 nRF5340-based devices running: samples/bluetooth/periodic_adv_rsp samples/bluetooth/periodic_sync_rsp with the PAwR configuration (modified...
14 views

0 replies

Started 9 hours ago
by droid
Not Answered
Benchmark for BLE receiver performance 0

Hello, we are testing the BLE ADV capabilities and also MESH performances on NRF54L15. We verified that, in conditions of continuous scanning (interval = 30ms), the packet...
18 views

0 replies

Started 14 hours ago
by barbiz
Not Answered
nrf52dk not visible in capture devise in Wireshark 0

Hi there, I went through all the documentation and instructions in order to use my nRF52DK as a sniffer and I can not see it in the capture devices in wireshark. am not...
27 views

0 replies

Started 15 hours ago
by Ludo
Not Answered
Can Twister be run without a full Zephyr source tree on the execution machine? 0

Hi, I’m working on a distributed testing pipeline where tests are built on one machine, but executed on a separate, lightweight container that does not contain the full...
18 views

0 replies

Started 16 hours ago
by igok99
Not Answered
Old PCA10056 v2.0.1 unable to connect/flash/erase 0

Hi, I took my old NRF52840 DK PCA10056 revision 2.0.1 and tried evaluating it today after few years. I am unable to connect to the target. I have 2 identical boards that were...
15 views

0 replies

Started 17 hours ago
by KrystofVydra

Recent in the DevZone Blog

Bluetooth pairing vulnerability

PaKa

The Bluetooth SIG released an errata for the 4.2 and 5.0 versions of Bluetooth specification on July 23rd relating to a potential vulnerability with the pairing procedures. For Bluetooth low energy; this…
- 27 Jul 2018
Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018
Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018