Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Linux USB ports 0

I have a nrf9160dk that drives a screen via SPI, using an IT8951 controller. The firmware driving the screen works fine if I plug the USB cable on a power bank or using MS...
10 views

0 replies

Started 6 hours ago
by amelio
Not Answered
9151 not able to read sim card 0

hi support team, customer is ordering sims from network supplier, and i got one sim card, but after testing i found this sim card can't be recognized. here is the modem...
11 views

0 replies

Started 15 hours ago
by William.wei
Not Answered
During the R&D phase, the testing of the Matter certification items failed 0

Hi， During the initial screening of Matter certification during the R&D phase, it was found that several test items did not pass the test. Could you please help investigate...
20 views

0 replies

Started 16 hours ago
by sean
Not Answered
nrf_pwr_mgmt_run(); is not executing in NRF52810 0

I’m working on an nRF52-based design where the device should remain in System ON low-power mode after an operation (SAADC sampling + BLE sync). After SAADC data collection...
21 views

0 replies

Started 1 day ago
by Tapan Nayak
Not Answered
FPROTECT for NRF54L10 0

I'm working with NRF54L10 module. I needed more mcuboot space so in pm_static.yml I allocated it 80kb. Before this FPROTECT was working but after I allocated 80kb, now FPROTECT...
23 views

0 replies

Started 1 day ago
by Amaan Singh

Recent in the DevZone Blog

Comparing compilers/IDEs for development with nRF5x series devices

Michael Dietz

#Introduction All compilers ARE NOT created equal. Given the same c code, different compilers will generate machine code with varying performance & size. Generally the more efficient machine code (uses…
- 28 Jan 2016
nRF52 Range Extension with RFaxis' RFX2411N

Floyd Ashbaugh

External Power Amplifiers and LNAs easily connected to the nRF52 series device for high power extended range operation. Data sheets, white papers, schematics and layout information available at link t…
- 26 Jan 2016
Developing Nordic nRF51 applications with mbed and Visual Studio

ivan

This tutorial shows how to use the mbed framework to develop applications for Nordic nRF51 devices. Before you begin, install VisualGDB 5.1 or later. Start Visual Studio and open the VisualGDB Embedded…
- 26 Jan 2016
PA / LNA support in S132

Einar Thorsrud

The S132 SoftDevice for the nRF52 has support for enable/disable switching of external Power Amplifiers (PA) and Low Noise Amplifiers (LNA) using GPIO pins. This was introduced in S132 version 2.0.0-7…
- 25 Jan 2016
Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016