Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
PAwR response delayed by one periodic interval 0

Hello, We are using 2 nRF5340-based devices running: samples/bluetooth/periodic_adv_rsp samples/bluetooth/periodic_sync_rsp with the PAwR configuration (modified...
4 views

0 replies

Started 5 minutes ago
by droid
Not Answered
Benchmark for BLE receiver performance 0

Hello, we are testing the BLE ADV capabilities and also MESH performances on NRF54L15. We verified that, in conditions of continuous scanning (interval = 30ms), the packet...
12 views

0 replies

Started 5 hours ago
by barbiz
Not Answered
nrf52dk not visible in capture devise in Wireshark 0

Hi there, I went through all the documentation and instructions in order to use my nRF52DK as a sniffer and I can not see it in the capture devices in wireshark. am not...
22 views

0 replies

Started 6 hours ago
by Ludo
Not Answered
Can Twister be run without a full Zephyr source tree on the execution machine? 0

Hi, I’m working on a distributed testing pipeline where tests are built on one machine, but executed on a separate, lightweight container that does not contain the full...
15 views

0 replies

Started 7 hours ago
by igok99
Not Answered
Old PCA10056 v2.0.1 unable to connect/flash/erase 0

Hi, I took my old NRF52840 DK PCA10056 revision 2.0.1 and tried evaluating it today after few years. I am unable to connect to the target. I have 2 identical boards that were...
13 views

0 replies

Started 8 hours ago
by KrystofVydra

Recent in the DevZone Blog

nRF51822 now supports extended industrial temp range (-40 – 105C)

Pär H

We recently announced that we now support “extended industrial temperature range” (-40 – 105C) on our nRF51822. The devices supporting -40 - 105C are the QFAA (QFN with 256kB flash and 16kB RAM) and the…
- 24 Aug 2015
Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015