Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
cellular turn off upon location wait. 0

I want to fix the problem of insufficient time windows when I search for a fix. I know that the recommended way is to use priority mode + EDX + PSM, but I tried to just turn...
10 views

0 replies

Started 12 minutes ago
by shlomots
Not Answered
uart30 receive issue 0

Dear Nordic, i have started my application with toolchain & sdk both v3.3.0, using custom services & charachteristics, with BLE advertising @500ms interval works fine. but...
14 views

0 replies

Started 1 hour ago
by Khodidas11
Not Answered
How to set the nRF21540-DK using basic sample (peripheral nus) with 20dBm TX power ? 0

Hello, How to config FEM on "nRF21540-DK" to set the TX power as +20dBm ?? I used the "perpheral_nus" sample (basic Bluetooth LE sample) in NCS 3.2.4 version Also...
25 views

0 replies

Started 4 hours ago
by Daewoong Kim
Not Answered
UART TX timing differs between ISR callback and workqueue 0

Hello Nordic team, Environment: SDK 3.1.0 nRF54L15 UART / RS-232 I am seeing different UART TX timing depending on whether I transmit from inside the UART RX...
54 views

0 replies

Started 15 hours ago
by kamaln16
Not Answered
Scene Save Issue – Blind Position Not Visible in Scene Configuration 0

While configuring a scene, the blind device is not visible in the scene settings screen, so it is not possible to set or save the blind position as part of the scene. Steps...
81 views

0 replies

Started 8 days ago
by Harsh0

Recent in the DevZone Blog

The S132 v5.1.0 is now production tested on nRF52810

Petter Myhre

This blog describes how you can setup a Segger Embedded Studio example for PCA10040E (emulating nRF52810) from nRF5 SDK 14.2 to use S132 v5.1.0, instead of S112. The procedure should be similar for the…
- 12 Sep 2018
Adding custom commands to a BLE example using Nordic UART Service

Håvard

A common thing to do is to use the Nordic UART Service for quick prototyping. Often the example itself is used as a starting point (ble_app_uart). But sometimes we use other starting points, and want to…
- 6 Sep 2018
Using Two-Factor Authentication (2FA) with the Nordic DevZone

esivertsen

Did you know you can use two-factor authentication to enhance the security of your DevZone account? In this little blog, I’ll show you how to enable Two-Factor Authentication (2FA) with your DevZone account…
- 30 Aug 2018
Introduction of SDH and SDK v15.0 software architecture

Amos Lin

The SDK software architecture has been hugely changed since SDK v13.0. With adding SDH to SDK, it provides SDH API to Enabling the SoftDevice and its event interrupt. Disabling the SoftDevice. Receiving…
- 13 Aug 2018
Bluetooth pairing vulnerability

PaKa

The Bluetooth SIG released an errata for the 4.2 and 5.0 versions of Bluetooth specification on July 23rd relating to a potential vulnerability with the pairing procedures. For Bluetooth low energy; this…
- 27 Jul 2018
Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018