Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
54L15 Timer Interrupt cost too high. How to reduce interrupt cost? 0

As title Situration: 1. Timer00 2. every 4us interrupt occur result: 1. Enter Timer interrupt cost 700ns 2. Leave Timer interrupt cost 200ns 3. Totol cost...
37 views

0 replies

Started 9 hours ago
by Austin (S.F.)
Not Answered
Using the Softdevice Controller without RTC Crystal 0

I want to use the Softdevice Controller without a crystal on the RTC. I configured my project with Advertiements look fine, but interaction with a BLE central either throw...
57 views

0 replies

Started 19 hours ago
by Sven Haedrich
Not Answered
NRF5340-AUDIO Unicast-Server / Unicast-Client configuration 0

Hi everyone, These days I'm evaluating the Nordic nRF5340 to manage audio from two microphones to one dongle station. To achieve this, I configured two nRF5340s as unicast...
54 views

0 replies

Started 20 hours ago
by Pier Luigi
Not Answered
Planning to use 3.7V non-Rechargable battery with npm2100 with an additional diode? 0

I am planning to use 3.7V non Rechargable Battery with Diode and Reverse Protection circuit with npm2100, Would like to build a Fuel Guage model for this as this is not available...
52 views

0 replies

Started 21 hours ago
by rsramki
Not Answered
MCELL search type for lte_lc_neighbor_cell_measurement() 0

Hello, I am currently evaluating MCELL location on an existing project, based on nRF9160. After some trial and errors, I managed to get it working. However, I ma a bit...
38 views

0 replies

Started 22 hours ago
by Vincent44

Recent in the DevZone Blog

Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018