Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
nRF Fuel gauge SOC calculation issue 0

Hi! I'm testing the application with the custom Battery pofile I generated with nPM PowerUP app. During testing I found the issue with the SOC value calcultation depending...
10 views

0 replies

Started 29 minutes ago
by AntonZ
Not Answered
Unable to Use Only MOSI Line in SPI Configuration (Zephyr, WS2812) 0

I am using the Zephyr SPI driver to control a WS2812 LED strip through the SPI interface. Since only the MOSI line is required for communication, I want to configure the SPI...
11 views

0 replies

Started 33 minutes ago
by Ivenhor
Not Answered
I2C not working with ns target 0

Using nrf5340dk, SDK v1.9.0 Want to add external RTC via I2C to wake mcu up via alarm, Facing Issue with I2C init. I have gone through the suggested sdk fundamental course...
9 views

0 replies

Started 37 minutes ago
by AP
Not Answered
OpenThread network working on Battery 0

I am using OpenThread network and working on CoAP Client and Server examples (Customized). Everything working fine when devices are on main power. My client devices are...
6 views

0 replies

Started 38 minutes ago
by ArunRuchir
Not Answered
psa_import_key, error -134 and bus fault 0

I am creating a sas token to azure iot hub on the nrf9160dk, and I have my access key provided by azure and I have base64 decoded it and using it as key and I want to store...
- software
- nRF9160
- Evaluation
- zephyr
13 views

0 replies

Started 1 hour ago
by NordicCoder

Recent in Nordic blog

New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018

Latest guides

Software and Protocols: Automating nRF91 TLS credential management via serial port AT commands

Daniel Veilleux

I have spent a bit of time recently experimenting with different TLS credential configurations using nRF91-DKs. Eventually I got to the point where I wanted to do things like swap out the certificates…
- 10 Jan 2020
Getting started: nRF Connect for Cloud Certificate Update

Joakim

The content of this guide is now covered in the documentation on nrf Connect SDK documentation page.For the most up-to-date instruction to Update Cloud Certificate please follow this link.
- 27 Sep 2019
Getting started: Thingy:91 Firmware Update using MCUboot

Joakim

The nRF Connect Programmer application now also supports MCUboot! Follow these steps to update through the programmer application or the following guide for the command line alternative. This guide shows…
- 23 Sep 2019
Bluetooth low energy: Concurrent Advertising

Håvard

I have been asked several times about variations of the following advertising scenario, so I decided to make a blog post that I can refer to, and hope it might prove useful for others out there that are…
- 9 Sep 2019
Software and Protocols: The four kinds of data you need to consider when developing an IoT product

Markus Tacker (he/him)

In this post I will give you an introduction to the four kinds of data you need to consider when developing an IoT product: Device State Device Configuration Past Data Firmware Updates It's these …
- 9 Sep 2019
Getting Started : Automate building of HEX files for your nRF Connect SDK application using CircleCI or GitHub Actions

Markus Tacker (he/him)

Continuous delivery is in important aspect of short time to market and since the nRF9160 supports firmware over the air updates we want to ship a new firmware to our development boards every time we update…
- 14 Aug 2019