Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Understanding "S1-U data transfer: Not supported" with nRF9160 on Private NB-IoT (Network Owner Claims Modem Origin) 0

Hello, I am using an nRF9160 to connect to a private network. My nRF9160 successfully attaches to this network. However, when reviewing the logs from the private network...
7 views

0 replies

Started 30 minutes ago
by l0cszp
Not Answered
nRF54L15 continuous wave mode 0

Hello, How can I put the nRF54L15 into continuous wave mode? And I assume after entering CW that I can freely change channels using the FREQUENCY register (0x708). Is that...
24 views

0 replies

Started 5 hours ago
by kitc22
Not Answered
Adding Actinius Icarus nRF9160 as LTE device in nRF cloud 0

Hi, I'm currently trying to add an Actinius Icarus IoT board as LTE device at nRF cloud. I already know my board IMEI (I got it by flashing the AT client sample and then...
22 views

0 replies

Started 8 hours ago
by Rocio Cabral
Not Answered
nrf21540 PDN default or high impedance state 0

Connecting nrf21540 to a nrf52840. 840 GPIO default state is input, input buffer connected. One of the 840 GPIO pins is connected to the 540 PDN pin. 1) If the 840 gets...
20 views

0 replies

Started 9 hours ago
by Namklak
Not Answered
nRF5340 Dual Role Issue: BLE Mesh Node + GATT Server (BLE Peripheral) Not Working in Parallel 0

I am currently developing a firmware application on the nRF5340 where I need the device to function in dual role : As a Bluetooth Mesh Node , communicating with other...
24 views

0 replies

Started 11 hours ago
by Pallavi Gundre

Recent in Nordic blog

Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015