Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Using the Softdevice Controller without RTC Crystal 0

I want to use the Softdevice Controller without a crystal on the RTC. I configured my project with Advertiements look fine, but interaction with a BLE central either throw...
36 views

0 replies

Started 7 hours ago
by Sven Haedrich
Not Answered
NRF5340-AUDIO Unicast-Server / Unicast-Client configuration 0

Hi everyone, These days I'm evaluating the Nordic nRF5340 to manage audio from two microphones to one dongle station. To achieve this, I configured two nRF5340s as unicast...
37 views

0 replies

Started 8 hours ago
by Pier Luigi
Not Answered
Planning to use 3.7V non-Rechargable battery with npm2100 with an additional diode? 0

I am planning to use 3.7V non Rechargable Battery with Diode and Reverse Protection circuit with npm2100, Would like to build a Fuel Guage model for this as this is not available...
30 views

0 replies

Started 9 hours ago
by rsramki
Not Answered
MCELL search type for lte_lc_neighbor_cell_measurement() 0

Hello, I am currently evaluating MCELL location on an existing project, based on nRF9160. After some trial and errors, I managed to get it working. However, I ma a bit...
24 views

0 replies

Started 9 hours ago
by Vincent44
Not Answered
How to Set TX Power for Response Packets in periodic_sync_conn? 0

HI I am currently using the nRF54L15 chip with NCS 3.2.1, carrying out secondary development based on the periodic_sync_conn sample project. I intend to adjust the transmit...
30 views

0 replies

Started 14 hours ago
by joey

Recent in the DevZone Blog

FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015