Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
nRF54L15 QSPI Maximum Speed 0

For the nRF54L15 QSPI software peripheral, is there any guidance on the maximum achievable clock rate?
8 views

0 replies

Started 15 minutes ago
by Adam M
Not Answered
Provisioning PSK at Manufacturing 0

Hi, I'm working on provisioning a Pre-Shared Key (PSK) during manufacturing for an nRF5340 device. The device needs access to the PSK at runtime to generate authentication...
- development
- software
- nRF Connect SDK
- C
- nRF5340
- arm
9 views

0 replies

Started 17 minutes ago
by hugzy123
Not Answered
Wake up after sys_poweroff() via GPIO inconsistent 0

I was doing a demo code to implement a wake up triggered by motion. I was able to make it work with the integrated low power accelerometer on thingy52 but it only worked 1...
11 views

0 replies

Started 33 minutes ago
by yopoitio
Not Answered
Try to build peripheral-uart example for nrf54L15-DK without west 0

Hello at all, I try to compile the example peripheral_uart for the nrf54L15-DK. The goal is to compile without west. My directory structure: where I copied everything from...
16 views

0 replies

Started 1 hour ago
by Neum_d
Not Answered
Is UART1/VCOM1 on nRF9161 used ? 0

Hello, I've a nRF9161DK board and I would like to connect a UART to an external device. Looking at the schematics I see that both UART0 and UART1 of nRF9161 are connected...
15 views

0 replies

Started 1 hour ago
by JOEBRE

Recent in Nordic blog

Programming the nRF51822 Beacon Kit with the nRF51DK

Stefan Birnir Sverrisson

One way to program the nRF51822 Bluetooth Smart Beacon Kit is to use the nRF51 DK. This gives you a full scale development platform (the nRF51 DK). This blog will go thru the steps needed to program…
- 7 May 2015
Bluz, a cloud connected Bluetooth LE development kit based on the nRF51822, is live on Kickstarter

eric ely

Bluz is a brand new development kit that brings Bluetooth LE to the internet. We have paired up with Spark and ported their FW to the nrf51822, allowing Bluz to be controlled and programmed over the…
- 15 Apr 2015
nRF51 current consumption for common scenarios

Stefan Birnir Sverrisson

The following is the estimated nRF51 current consumption during advertising with the DCDC disabled. Advertising 1: TX power: +4dBm adv interval: 20ms (minimum advertising interval in normal adversising…
- 14 Apr 2015
Building kernel for RPi2 with bluetooth_6lowpan for Raspbian

Håkon Alseth

Building kernel for RPi2 with bluetooth_6lowpan In this guide, you will have two choices: Cross-compilation build Native build Choose the one that fits your needs. Cross-compilation is…
- 9 Apr 2015
Debugging with Real Time Terminal

FormerMember

In SDK 12.0.0 or later, logging/debugging over RTT is built in to the logger module NRF_LOG. To enable logging over RTT, "check" the NRF_LOG_BACKEND_SERIAL_USES_RTT option in sdk_config.h in the configuration…
- 8 Apr 2015
Accessing the BLE mesh via the particle.io (spark.io) cloud

David Edwin

Hello. I was spending the last few days to implement an interface to access the BLE mesh via the Internet. The mesh consists of devices with LEDs, which then could be turned on and off in my browser.…
- 1 Apr 2015