Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
what is the maximum size of CoAP? 0

Hi all: I know the minimum size of CoAP is 4 bytes. what is the maximum size of CoAP?
- iot coap
915 views

0 replies

Started over 10 years ago
by chao
Not Answered

IPV6 mesaages in implementation of iot sdk 0

After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...

580 views

0 replies

Started over 10 years ago
by FormerMember
Not Answered
nRF8001 SDK needed! 0

Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code. I don't have any registration key, how do I get hold of it? ...
- nrf8001 sdk
529 views

0 replies

Started over 10 years ago
by Silvere Letellier
Not Answered
Bricked my brand new nRF51-DK? 0

Hi, I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
- nrf51-dk
795 views

0 replies

Started over 10 years ago
by David
Not Answered

master slave, link 0

Hello, I would like to do an communication between Arduino and Android platform. In my case, Android will be master. But I want also test between 2 Arduino with an Bluetooth...

556 views

0 replies

Started over 10 years ago
by Vorms

Recent in Nordic blog

nRF51822 now supports extended industrial temp range (-40 – 105C)

Pär H

We recently announced that we now support “extended industrial temperature range” (-40 – 105C) on our nRF51822. The devices supporting -40 - 105C are the QFAA (QFN with 256kB flash and 16kB RAM) and the…
- 24 Aug 2015
Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015