Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Looking for an english or hungarian speaking developer 0

We are looking for an experienced software developer, for existing board with using nRF Connect SDK. We are using nRF52840-dk. Please, contact me if you are interested.
720 views

0 replies

Started over 2 years ago
by Norbert Ambrus
Not Answered
openthread and mcumgr with uart0 and uart1 via usb 0

Close, this is being discussed here: Thanks
604 views

0 replies

Started over 2 years ago
by JuanAlm
Not Answered
Where do I find the presentation for the Building more reliable Bluetooth LE products with Memfault webinar? 0
600 views

0 replies

Started over 2 years ago
by Ali Aljaani
Not Answered
nRF Connect for Desktop advertising restart after disconnect 0

Hi After each connection, I should press Alt-A. Is it possible to add a feature so the advertising will restart automatically after the connection is finished?
622 views

0 replies

Started over 2 years ago
by Mike Tuev R9FT
Not Answered
case about nRF9160 program modem 0

none
627 views

0 replies

Started over 2 years ago
by peter.min

Recent in Nordic blog

FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015