Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
nRF UART App error 0

Hi, i use anRF51822 with soft device 7. I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5. Both devices connected...
- s110
- bluetooth low energy
- uart
- keil
- nrf51822
- nordic
1727 views

0 replies

Started over 10 years ago
by max
Not Answered
nRFgo Studio will not launch after upgrading to 1.17.0 0

Hello, I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
- nrf51822 nrfgo
953 views

0 replies

Started over 10 years ago
by Archie
Not Answered
Error when send data from ios to nRF51822 0

Hi, i tried to send data from ios 7 via tx_characteristics(like in UART example) but received error: didWriteValueForCharacteristic 2A38 error = Error Domain=CBErrorDomain...
- s110
- bluetooth low energy
- io
- nrf51822
858 views

0 replies

Started over 10 years ago
by max
Not Answered
Help Setting up Eclipse IDE w/ JLinkGDB on Mac OSX 0

I have been trying for a few days now to get my environment setup for development with the nRF51822. Since there is no official configuration for the Mac w/ Eclipse I have...
- eclipse
- nrf51822
1353 views

0 replies

Started over 10 years ago
by Scott Piette
Not Answered

Answers are losing spaces 0

Apologies if this has been asked before but did search for 'format' in faq and got nothing. I have been answering to questions. In my answer I place hard empty lines....

451 views

0 replies

Started over 10 years ago
by Mahendra Tailor

Recent in Nordic blog

Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015