Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Best practices for robust fault recovery with nRF51822? 0

I will be deploying my nRF51822-powered devices into the field and the end user will not be able to have any physical access to, for example, power cycle the board. I need...
- watchdog
- s110
- nrf51822
999 views

0 replies

Started over 10 years ago
by Mike Robbins
Not Answered
nRF UART App not resposnding after some time 0

Hi, We are using the ble_app_uart example in evaluation board to read data from some sensors and send it to the nRF UART V2.0 in Android 4.4. Every 20 ms I am trying to...
- s110 v6
- keil
- nrf51822
834 views

0 replies

Started over 10 years ago
by Shafy
Not Answered
SDK6 how to save multiple whitelist? 0

I am try this at nrf51_sdk_v6_0_0_43681\nrf51822\Board\nrf6310\s110\ble_app_hids_keyboard Firt I connect to Android device and keep one whitelist.pp_addrs and one whitelist...
- whitelist
- sdk6.0
- s110
- nrf51822
892 views

0 replies

Started over 10 years ago
by gootoomoon
Not Answered
Parameter not implemented : uint8_t ble_gap_scan_params_t::filter 0

Hi, Parameter uint8_t ble_gap_scan_params_t::filter is present in the documentation, but not implemented. Checked for SDK 5.2.0 and 6.0.0. devzone.nordicsemi.com...
- nrf51 sdk softdevice s120
510 views

0 replies

Started over 10 years ago
by Sébastien Despont
Not Answered
StartServiceDiscovery fails after disconnection (VS10, C#) 0

After I get a Disconnected() event, I want to start scanning again, therefore try to call StartDeviceDiscovery() again. IsDeviceDiscoveryOngoing was checked before. The...
- masteremulator
- mcp
- c#
1008 views

0 replies

Started over 10 years ago
by Damien

Recent in Nordic blog

Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018
Introducing experimental release of Programmer Application

Reidar Martin Svendsen

nRF Connect for desktop has proven its flexibility by being cross platform and ability to install and update applications based on users need. Motivation Our initial goal was to modernize and cover…
- 30 Apr 2018
New in nRF5 SDK v15: Strong Hardware-Based Security with Infineon OPTIGA Trust X

ChristianLesjak

Defining a business model and implementing a technical infrastructure are two major phases in building a successful product or IoT system. However, protecting the business model and your customer’s data…
- 9 Apr 2018