Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered

Retry Pairing Procedure 0

Does the s110 stack allow retrying pairing procedure? It looks like the stack (peripheral) always ends with disconnect upon invalid passkey. We would like to explore the...

692 views

0 replies

Started over 10 years ago
by Chaowen Young
Not Answered

device disconnects with the client after cutting the link SB8 for current measurement in nRf51822 eKit.any solution ?? 0

the sB8 link was cut for current measurement .but now no services are enabled and the device doesnt connects to master .pls help !!!

564 views

0 replies

Started over 10 years ago
by hrg
Not Answered

DFU-OTA with S110 v7a3 and nRFToolBox on iPhone 5S 0

Hi Guys, since yesterday i am trying to get the DFU with Softdevice S110 (BLE) v7-alpha3 working but haven't succeeded yet. My process is the following: s110_nrf51822_7...

961 views

0 replies

Started over 10 years ago
by Marius R.
Not Answered
relation in channel and pin 0

Hi All, i would like to know about 1) what is channel in nrf51288? 2) is there any mathematical relationship between channel no and pin no as in ble_app_hrs example channel...
604 views

0 replies

Started over 10 years ago
by renu
Not Answered
uart(with USB to UART bridge) dfu can not work 0

Hi, I use UART bootloader SDK example(dfu_dual_bank_hci) to do update firmware on EK PCA10001 board,it can work ok.But i changed the HCI_SLIP_UART_RX_PIN_NUMBER and HCI_SLIP_UART_TX_PIN_NUMBER...
- dfu with hci
995 views

0 replies

Started over 10 years ago
by jay

Recent in Nordic blog

FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015