Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
The role of this device is remote measurement environment parameters.
It could be accessed anywhere where access to the internet is possible.
It uses 6LoWPAN because it's modern IoT technology and have…
I've written up a note on programming external nRF51822 boards (like the RedBearLab Nano) using the SWD interface of the nRF51-DK.
http://electronut.in/nrf51-dk-external-programming/
I've written up a simple project that uses the nRF51-DK to send LDR light levels over BLE using the Nordic UART Service (NUS). In the process, I have set up a cross-platform toolchain (OS X, Windows) using…
Before we begin
Table of context
Before we begin
The "Hello world" example
Advertising
RSSI
Addresses
Address types
Advertising types
Bonding
Advertising data
Scan response data
Change Log 2018…