Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Gazell library source code. 0

Hi I have a question about using gazell link layer and paring library with concurrent timeslot api. I try to do this but i have the hard fault handler after invoked nrf_gzll_init...
- gazell
- nrf51822
1694 views

0 replies

Started over 12 years ago
by Firek
Not Answered

PWM / Timer question 0

HI, I want to use PWM to control various hardware (LED's, etc ..) so I started off from the suggested PWM code example, found in this forum + modified it as I want to use...

3230 views

0 replies

Started over 12 years ago
by Jacques
Not Answered

what's the function of the paramter BLE_L2CAP_MTU_DEF? 0

hello, the function ble_stack_init () in the example of ble_app_uart are quite different from that in the example of ble_app_proximity in my first sight. ble_app_uart :...

2553 views

0 replies

Started over 12 years ago
by dangerous_man
Not Answered

Is there any doc for nrf-beacon-lib ? 0

Hi All, We're working on nrf-beacon app on Android with nrf-beacon-lib.jar. Is there any doc for this lib ?

822 views

0 replies

Started over 12 years ago
by Sam Lin
Not Answered

nRF51822-EK Eclipse gets me an "Error in final launch sequence" 0

I am getting following error: Error in final launch sequence Error executing step execute method: stepInitializeJTAGFinalLaunchSequence java.lang.reflect.InvocationTargetException...

1042 views

0 replies

Started over 12 years ago
by Mark Chekhanovskiy

Recent in the DevZone Blog

The S132 v5.1.0 is now production tested on nRF52810

Petter Myhre

This blog describes how you can setup a Segger Embedded Studio example for PCA10040E (emulating nRF52810) from nRF5 SDK 14.2 to use S132 v5.1.0, instead of S112. The procedure should be similar for the…
- 12 Sep 2018
Adding custom commands to a BLE example using Nordic UART Service

Håvard

A common thing to do is to use the Nordic UART Service for quick prototyping. Often the example itself is used as a starting point (ble_app_uart). But sometimes we use other starting points, and want to…
- 6 Sep 2018
Using Two-Factor Authentication (2FA) with the Nordic DevZone

esivertsen

Did you know you can use two-factor authentication to enhance the security of your DevZone account? In this little blog, I’ll show you how to enable Two-Factor Authentication (2FA) with your DevZone account…
- 30 Aug 2018
Introduction of SDH and SDK v15.0 software architecture

Amos Lin

The SDK software architecture has been hugely changed since SDK v13.0. With adding SDH to SDK, it provides SDH API to Enabling the SoftDevice and its event interrupt. Disabling the SoftDevice. Receiving…
- 13 Aug 2018
Bluetooth pairing vulnerability

PaKa

The Bluetooth SIG released an errata for the 4.2 and 5.0 versions of Bluetooth specification on July 23rd relating to a potential vulnerability with the pairing procedures. For Bluetooth low energy; this…
- 27 Jul 2018
Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018