Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
channel sounding cs channel map update instant passing 0

I enable cs procedure and set the procdure count equals to 3, let procedure interval to be 10. I want to change the cs channel map between procedures. so when I send HCI_LE_CS_Set_Channel_Classification...
39 views

0 replies

Started 1 day ago
by zhuxi
Not Answered
BLE Callbacks: Who Connected? Central or Peripheral 0

Hi, I am working with the nRF54L15 and I want to use it both as a BLE central and as a BLE peripheral. So, I have two separate source files: one for central and one for...
- development
- software
- nRF54L15
- zephyr
- bluetooth le
19 views

0 replies

Started 1 day ago
by witc
Not Answered
ota error:The image does not have a valid mcu header 0

Hi all, nrf54l15dk,v3.0.1,peripheral_uart demo and no changes have been made. Then add the following content to prj.conf sysbuild.conf mcuboot.conf Finally...
25 views

0 replies

Started 1 day ago
by 666
Not Answered
Android 15 introduces bug where bonded devices cannot be disconnected 0

We use several Nordic chips in our BLE sensors. We bond to the devices from Android, connect to update configurations, then disconnect such that the device then advertises...
171 views

0 replies

Started 26 days ago
by RickW
Not Answered
4Roads Test - PLEASE IGNORE 0

4Roads Test - PLEASE IGNORE
130 views

0 replies

Started 1 month ago
by Sneh4RTest

Recent in Nordic blog

nRF51822 now supports extended industrial temp range (-40 – 105C)

Pär H

We recently announced that we now support “extended industrial temperature range” (-40 – 105C) on our nRF51822. The devices supporting -40 - 105C are the QFAA (QFN with 256kB flash and 16kB RAM) and the…
- 24 Aug 2015
Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015