Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
I2S Master Frequency Stuck at 10 kHz 0

Hi there, This is a follow up post from my earlier one here about using nRF5340 dk as an I2S master for the purpose of recording sound using a MEMS sensor ICS43434. Here...
148 views

0 replies

Started 4 months ago
by umer
Not Answered
Reusing main thread's stack after terminating 0

Hello DevZone! All samples with Application Event Manager (CAF, nRF Desktop) has simple main function like that: Main thread has terminated after executing and main...
157 views

0 replies

Started 4 months ago
by kchuva
Not Answered
Fail to debug E83-2G4M03S with nRF5340 0

Hello! I bought dev board with this module and plan to use it in my product. I bought a development board with this module and plan to use it in my product. While I...
189 views

0 replies

Started 4 months ago
by Rasul Kishov
Not Answered
Optimizing 10 kHz Data Stream Merging & De-duplication 0

Hi all, I'm working on a Nordic-based system involving multiple nRF52-series chips exchanging high-rate sensor data over both radio and SPI links. The setup involves two...
- development
- code
- software
- nRF52833
- 2.4 ghz
- proprietary
- C
165 views

0 replies

Started 5 months ago
by Floppey
Not Answered
Test 0

Practice ticket
159 views

0 replies

Started 5 months ago
by sly

Recent in the DevZone Blog

nRF51822 now supports extended industrial temp range (-40 – 105C)

Pär H

We recently announced that we now support “extended industrial temperature range” (-40 – 105C) on our nRF51822. The devices supporting -40 - 105C are the QFAA (QFN with 256kB flash and 16kB RAM) and the…
- 24 Aug 2015
Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015