Hi Nordic Team,
I am using the nRF52840 microcontroller and have interfaced a modem with one of its UART modules, as my modem communicates with the Nordic chip via UART...
Hello All,
I am hoping someone can provide a recommendation regarding the matching circuit for my antenna using nRF54L15. Please see the attached schematic for reference...
Hello everyone! I am having some trouble in connecting two peripherals to a single central station.
As peripherals I'm using 2 nRF5340DK flashed with the UART-Peripheral...
I have a project that was building, but now on restarting VS Code, I cannot access the build configurations.
The list shows a configuration as present, but when I expand...
Hello,
I have an NRF9160DK board and a custom board running the SLM application that are exhibiting similar behaviour. Both boards work fine with the supplied iBasis SIM...
An automatic radio test was developed based on Enhanced Shockburst (ESB), which works for
all the nRF Series Chips including, nRF24LE1, nRF24LU1P, nRF51x22, as well as nRF52832. Source code is available…
Over the last few weeks the Nordic team has been working on getting support for programming our devices in Linux as well as adding support for using our Python programming module ‘Pynrfjprog’ with Python…
OSX command line application for performing an nRF51 device firmware update:
https://github.com/jeremysf/nrfDFU
This is a simple command line program I wrote based on Nordic's documentation and their…
In this post I will give you an introduction to the four kinds of data you need to consider when developing an IoT product:
Device State
Device Configuration
Past Data
Firmware Updates
It's these …
Continuous delivery is in important aspect of short time to market and since the nRF9160 supports firmware over the air updates we want to ship a new firmware to our development boards every time we update…
Nordic's Power Profiler Kit (PPK) is an inexpensive piece of hardware that can provide a significant amount of insight into the operation and performance of your project. Although there is a lot that…
This project was originally made in an outdated version of NCS, but it has now been updated to NCS v1.5.0. The instructions are the same as before, but the code is different.
Disclaimer: This is a student…
Purpose
This document will show how to automate the provisioning process for Nordic BLE Mesh nodes using Python scripting. When provisioning nodes using PyACI (Python Application Controller Interface)…
I implemented parts of the BLE-MIDI service along with a small example application. I wanted to share it here on the blog, in case someone would find it useful. The intended audience is primarily someone…