Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Drain current on Txd pin 0

Hi, I'm interfacing a nrf51822 and a H8/3294. My question is how much can I drain a the txd pin of the H8/3294. That means my question isn't really about nrf51822. In documentation...
- output current pin
533 views

0 replies

Started over 7 years ago
by Jief
Not Answered
LFXO active with 0.5μA higher current 0

Hi, On the 3.30 of nRF52832_Rev_1_Errata_v1.5.pdf, the sleep current with LFXO active is 0.5μA higher. I am using a nRF52832 module with the low frequency crystal oscillator...
- nrf52
- s132
- lfxo
670 views

0 replies

Started over 7 years ago
by ALE
Not Answered

Wouldn't update connection params 0

Hi, I'm using nRF52832 on SDK V12.2. I add the connection params in the conn_params_init: static void conn_params_init(void){ uint32_t err_code; ble_conn_params_init_t...

715 views

0 replies

Started over 7 years ago
by Alice
Not Answered
how to use whitelist in ble_app_hrs_c 0

S130, SDK 12.3, ble_app_hrs_c example. I want to use whitelist function in this example but I can't finish it. When I run peer_list_get(), it gets all 0xFF, means that...
- s130
- whitelist
- ble_app_hrs_c
- nrf51822
873 views

0 replies

Started over 7 years ago
by kamisen
Not Answered

services size is zero 0

sometime,i use android app to scan ble device,it will display "the device dose not has required services",the gatt.getServices.size is zero.why?

533 views

0 replies

Started over 7 years ago
by nowen

Recent in Nordic blog

New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018

Latest guides

Software and Protocols: Automating nRF91 TLS credential management via serial port AT commands

Daniel Veilleux

I have spent a bit of time recently experimenting with different TLS credential configurations using nRF91-DKs. Eventually I got to the point where I wanted to do things like swap out the certificates…
- 10 Jan 2020
Getting started: nRF Connect for Cloud Certificate Update

Joakim

The content of this guide is now covered in the documentation on nrf Connect SDK documentation page.For the most up-to-date instruction to Update Cloud Certificate please follow this link.
- 27 Sep 2019
Getting started: Thingy:91 Firmware Update using MCUboot

Joakim

The nRF Connect Programmer application now also supports MCUboot! Follow these steps to update through the programmer application or the following guide for the command line alternative. This guide shows…
- 23 Sep 2019
Bluetooth low energy: Concurrent Advertising

Håvard

I have been asked several times about variations of the following advertising scenario, so I decided to make a blog post that I can refer to, and hope it might prove useful for others out there that are…
- 9 Sep 2019
Software and Protocols: The four kinds of data you need to consider when developing an IoT product

Markus Tacker (he/him)

In this post I will give you an introduction to the four kinds of data you need to consider when developing an IoT product: Device State Device Configuration Past Data Firmware Updates It's these …
- 9 Sep 2019
Getting Started : Automate building of HEX files for your nRF Connect SDK application using CircleCI or GitHub Actions

Markus Tacker (he/him)

Continuous delivery is in important aspect of short time to market and since the nRF9160 supports firmware over the air updates we want to ship a new firmware to our development boards every time we update…
- 14 Aug 2019