Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
one wire library for nrf51822 keil 0

one wire library for nrf51822 keil for connected ds18b20 .
- nrf51822 keil one wire
745 views

0 replies

Started over 7 years ago
by morteza1994
Not Answered
Nordic NFR52832 Two Masters with FTDI SPI-USB Bridge 0

Hi all, I am making a device which involves using nfr52832(PCA10040) to communicate with a NAND flash through spi to store data acquired from the ADC. After all the data...
- c232hm
- adc
- qt
- nfr52832
- ftdi bridge
- spi
- keil
- spi-usb
972 views

0 replies

Started over 7 years ago
by bryanhsieh
Not Answered
Using semihosting with sdk11? 0

How to enable semihosting in sdk11 examples? This works, but I can't port it to examples/periferal/template_project :( changes: pca10028/armgcc/Makefile: adding...
1042 views

0 replies

Started over 7 years ago
by Petr Beklemishev
Not Answered

Data overflow while writing in flash 0

Hello, I want to store temperature samples in flash of nrf51822. I am using pca10028 and sdk 12.2.0. I have the code for writing,deleting and reading from flash memory....

1369 views

0 replies

Started over 7 years ago
by Newbie
Not Answered
Stack usage, IAR 0

Hello, I have a question about stack usage. I use nRF51822 SoC, 12.2 SDK & IAR 7.60.1. I am interested in stack usage. Have you done any estimations? Or may be you have...
- linker
- call stack
- s130
- iar
- nrf51822
4221 views

0 replies

Started over 7 years ago
by Artem Zemlyanukhin

Recent in Nordic blog

New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018

Latest guides

Software and Protocols: Automating nRF91 TLS credential management via serial port AT commands

Daniel Veilleux

I have spent a bit of time recently experimenting with different TLS credential configurations using nRF91-DKs. Eventually I got to the point where I wanted to do things like swap out the certificates…
- 10 Jan 2020
Getting started: nRF Connect for Cloud Certificate Update

Joakim

The content of this guide is now covered in the documentation on nrf Connect SDK documentation page.For the most up-to-date instruction to Update Cloud Certificate please follow this link.
- 27 Sep 2019
Getting started: Thingy:91 Firmware Update using MCUboot

Joakim

The nRF Connect Programmer application now also supports MCUboot! Follow these steps to update through the programmer application or the following guide for the command line alternative. This guide shows…
- 23 Sep 2019
Bluetooth low energy: Concurrent Advertising

Håvard

I have been asked several times about variations of the following advertising scenario, so I decided to make a blog post that I can refer to, and hope it might prove useful for others out there that are…
- 9 Sep 2019
Software and Protocols: The four kinds of data you need to consider when developing an IoT product

Markus Tacker (he/him)

In this post I will give you an introduction to the four kinds of data you need to consider when developing an IoT product: Device State Device Configuration Past Data Firmware Updates It's these …
- 9 Sep 2019
Getting Started : Automate building of HEX files for your nRF Connect SDK application using CircleCI or GitHub Actions

Markus Tacker (he/him)

Continuous delivery is in important aspect of short time to market and since the nRF9160 supports firmware over the air updates we want to ship a new firmware to our development boards every time we update…
- 14 Aug 2019