Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Why is there no win64 version of the ble-driver-win? 0

When you download win driver (from www.nordicsemi.com/.../72324929 for instance). There's only a win32 dll/lib provided. However, modern development are often made on 64bits...
- ble-driver-win
989 views

0 replies

Started over 8 years ago
by jpo38
Not Answered

Nrf24lu nrf51822 ESB 0

hello, Nrf24LU (Rx) , nRF51822(Tx). The Nrf24LU Can only receive one packet。 if I use this function twice ， like this： The Nrf24LU can receive Continuous. I guess The...

1088 views

0 replies

Started over 8 years ago
by charlesjoo
Not Answered

DFU device not visible with BLED112 0

Hi, I use SDK v10, S110 v8 and dfu_dual_bank_ble_s100_pca10028. My application has dfu support. I reset to bootloader from application after writing 0x0104 to dfu control...

659 views

0 replies

Started over 8 years ago
by gaminn
Not Answered
Hello all, my question is related to connection interval and to transmission distance. 0

I have a nRF51822 device. When the connection interval is 50ms. The transmission distance can up to 50m+. But, when the connection interval is 1000ms. The transmission...
4642 views

0 replies

Started over 8 years ago
by Ann Wen
Not Answered

ble-sniffer nrf51822 v 2.0 Kali Linux 0

Hi, I have a simple question. It is possible to use the ble-sniffer nrf51822 on Kali Linux? I found a guide to use it on linux but I don't know if it is the same for Kali...

1231 views

0 replies

Started over 8 years ago
by Matteo

Recent in Nordic blog

Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016
SEGGER Embedded Studio Part 2 - Monitor Mode Debugging

Michael Dietz

This tutorial will take less than 15 minutes. #Motivation Never lose a BLE connection when debugging your applications again! This technique will also be useful for any application using the PWM peripheral…
- 22 Jan 2016

Latest guides

Software and Protocols: Automating nRF91 TLS credential management via serial port AT commands

Daniel Veilleux

I have spent a bit of time recently experimenting with different TLS credential configurations using nRF91-DKs. Eventually I got to the point where I wanted to do things like swap out the certificates…
- 10 Jan 2020
Getting started: nRF Connect for Cloud Certificate Update

Joakim

The content of this guide is now covered in the documentation on nrf Connect SDK documentation page.For the most up-to-date instruction to Update Cloud Certificate please follow this link.
- 27 Sep 2019
Getting started: Thingy:91 Firmware Update using MCUboot

Joakim

The nRF Connect Programmer application now also supports MCUboot! Follow these steps to update through the programmer application or the following guide for the command line alternative. This guide shows…
- 23 Sep 2019
Bluetooth low energy: Concurrent Advertising

Håvard

I have been asked several times about variations of the following advertising scenario, so I decided to make a blog post that I can refer to, and hope it might prove useful for others out there that are…
- 9 Sep 2019
Software and Protocols: The four kinds of data you need to consider when developing an IoT product

Markus Tacker (he/him)

In this post I will give you an introduction to the four kinds of data you need to consider when developing an IoT product: Device State Device Configuration Past Data Firmware Updates It's these …
- 9 Sep 2019
Getting Started : Automate building of HEX files for your nRF Connect SDK application using CircleCI or GitHub Actions

Markus Tacker (he/him)

Continuous delivery is in important aspect of short time to market and since the nRF9160 supports firmware over the air updates we want to ship a new firmware to our development boards every time we update…
- 14 Aug 2019