Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered

Is NRF Beacon Kit compatible with S130? 0

Hello, I have looked into the compatibility matrix and I couldn't find any clear answer about if the NRF Beacon Kit is compatible or not with the S130. Does anyone tried to...

668 views

0 replies

Started over 9 years ago
by Daniel
Not Answered
about nrf24le1debug problem 0

hi: now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
- 24le1 debug
629 views

0 replies

Started over 9 years ago
by jerly
Not Answered

Communication timeout. Emulator did not re-enumerate 0

This is what I got after upgrading my nRF51 dongle firmware. It always times out. I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...

2090 views

0 replies

Started over 9 years ago
by Paul
Not Answered
APP which support to conect 8 or more BLE peripherals 0

Hi all, Good day. Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time. Thanks & Regards Jenson
- bluetooth low energy
626 views

0 replies

Started over 9 years ago
by Jenson
Not Answered

nRF51xxx debugging with BDI debugger 0

I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...

734 views

0 replies

Started over 9 years ago
by robertos

Recent in Nordic blog

nRF51822 now supports extended industrial temp range (-40 – 105C)

Pär H

We recently announced that we now support “extended industrial temperature range” (-40 – 105C) on our nRF51822. The devices supporting -40 - 105C are the QFAA (QFN with 256kB flash and 16kB RAM) and the…
- 24 Aug 2015
Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015