Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered

Communication timeout. Emulator did not re-enumerate 0

This is what I got after upgrading my nRF51 dongle firmware. It always times out. I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...

2090 views

0 replies

Started over 9 years ago
by Paul
Not Answered
APP which support to conect 8 or more BLE peripherals 0

Hi all, Good day. Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time. Thanks & Regards Jenson
- bluetooth low energy
626 views

0 replies

Started over 9 years ago
by Jenson
Not Answered

nRF51xxx debugging with BDI debugger 0

I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...

734 views

0 replies

Started over 9 years ago
by robertos
Not Answered

Scaner Design uisng nRF24L01 0

hi, I want to scan ism band to detect active nRF24L01 transmitters. How much time receiver will take to scan the whole band.?

798 views

0 replies

Started over 9 years ago
by adnan
Not Answered

Writing data using Python binding method 0

Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...

831 views

0 replies

Started over 9 years ago
by Owlman

Recent in Nordic blog

Multiple channels in RTT

Krzysztof Zaraska

Segger RTT (Real-Time Terminal) supports multiple data channels. RTT Viewer uses channel 0 only, and implements multiple virtual terminals on top of this. The terminal can be switched by SEGGER_RTT_SetTerminal…
- 29 Sep 2017
6 Things to Know about Bluetooth Beacons

Rose Martin

Smartphones and tablets have revolutionized the manner in which people communicate with each other. Mobile applications with location-based features like Bluetooth beacons, WiFi, and GPS are helping people…
- 22 Sep 2017
Creating a Keil project for a Bluetooth Mesh example (Updated for 0.10.0)

Kristian Skordal

Introduction The recently released nRF5 SDK for Bluetooth Mesh does not provide Keil project files for its example projects. Fortunately, it's relatively easy to set up your own project from scratch.…
- 19 Sep 2017
Using millis() like in Arduino.

schef

Here are two simple functions to use when you want to use timestamps for time measurement. uint32_t millis(void) { return(app_timer_cnt_get() / 32.768); } and for comperison of current with given…
- 18 Sep 2017
Flashing nRF5x firmware using any dumb terminal program via standard serial COM port

Nguyen Hoan Hoang

There are times that we needed to flash the nRF5x series on a PC where the development software were not installed. The problem could be worst when network access is limited. With a HEX file on hand…
- 18 Sep 2017
How to Debug the nRF52 Interrupts — Useful Tips

Yaniv Nis

Debugging interrupts in not an easy task. During the development of Jumper's Emulator, we gather few useful tips that we think can help you all when debugging the nRF52 interrupts. Hope it will help…
- 13 Sep 2017