Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Does the SWD and SCK goes high impedance when chip is in RESET state 0

Hi, I am now developing a production programmer and I want to know the behavior of SWD and SCK lines when the nRF52840 is in RESET state. Cheers, Kaushalya
7 views

0 replies

Started 27 minutes ago
by kaushalyasat
Not Answered
Inactive Scheduler actions are triggered after Time Set 0

Hello. I am experiencing an issue in Bluetooth Mesh where a Schedule entry that is set to "Inactive" is triggered when the time is updated. Steps to reproduce: Register...
12 views

0 replies

Started 1 hour ago
by a.da
Not Answered
Issue with Partition Manager to Devicetree migration on nRF54L15 (MCUboot + TF-M) 0

Hello. I am currently migrating a project from NCS v3.2.4 to v3.3.1 and transitioning from Partition Manager to devicetree-based partitioning, following the official migration...
14 views

0 replies

Started 1 hour ago
by a.da
Not Answered
BLE DFU nRF5280,nRF5340 0

mcumgr disconnecting when i trying to ble dfu .... " Log from nrf connect mobile app" nRF Connect, 2026-06-16 FYZKS52_E23993 (E2:39:93:7B:81:AA) V 17:16:59.495 Connecting...
17 views

0 replies

Started 1 hour ago
by Macherla Swetha
Not Answered
nRF52840 Dongle Serial Command List for external application 0

Hello, I have used nRF Connect for Desktop with the nRF52840 dongle and it works perfectly as far as using the dongle as a central device and a peripheral device (BLE advertising...
35 views

0 replies

Started 12 hours ago
by David Thomason

Recent in the DevZone Blog

Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018