Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
ALIRO: ValidityInfo — is signed < validFrom meant to be rejected? 0

Hi guys, I'm hitting an error with the current Aliro 1.0.0 lib. When a credential is signed today but its validFrom is in the future (e.g. signed=2026-06-17, validFrom...
10 views

0 replies

Started 30 minutes ago
by Jason
Not Answered
Unable to connect to blank nRF9151-LACA on custom board using nRF9151 DK external debugger 0

Hi, I am trying to program a custom board containing an nRF9151-LACA using the external programming interface (P20) on an nRF9151 DK. The board has never been programmed...
21 views

0 replies

Started 2 hours ago
by Plakkies
Not Answered
nRF Connect unable to complete installation of SDKs 0

I'm stuck trying to set my nRF Connect extension on VSC. I've followed the guide for the installation but I'm reaching a wall. Every time I try to install a given SDK I have...
31 views

0 replies

Started 3 hours ago
by Oriol0
Not Answered
Does the SWD and SCK goes high impedance when chip is in RESET state 0

Hi, I am now developing a production programmer and I want to know the behavior of SWD and SCK lines when the nRF52840 is in RESET state. Cheers, Kaushalya
22 views

0 replies

Started 5 hours ago
by kaushalyasat
Not Answered
Inactive Scheduler actions are triggered after Time Set 0

Hello. I am experiencing an issue in Bluetooth Mesh where a Schedule entry that is set to "Inactive" is triggered when the time is updated. Steps to reproduce: Register...
25 views

0 replies

Started 6 hours ago
by a.da

Recent in the DevZone Blog

Developing Nordic nRF51 applications with mbed and Visual Studio

ivan

This tutorial shows how to use the mbed framework to develop applications for Nordic nRF51 devices. Before you begin, install VisualGDB 5.1 or later. Start Visual Studio and open the VisualGDB Embedded…
- 26 Jan 2016
PA / LNA support in S132

Einar Thorsrud

The S132 SoftDevice for the nRF52 has support for enable/disable switching of external Power Amplifiers (PA) and Low Noise Amplifiers (LNA) using GPIO pins. This was introduced in S132 version 2.0.0-7…
- 25 Jan 2016
Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016
SEGGER Embedded Studio Part 2 - Monitor Mode Debugging

Michael Dietz

This tutorial will take less than 15 minutes. #Motivation Never lose a BLE connection when debugging your applications again! This technique will also be useful for any application using the PWM peripheral…
- 22 Jan 2016
An introduction to error handling in nRF5 projects

Audun

As you start developing with the nRF5 series chips, SoftDevices, and SDKs, it's very useful to learn how errors can be discovered (and preferrably recovered from). This can be detecting something as simple…
- 20 Jan 2016