• State Verified Answer
  • Replies 5 replies
  • Subscribers 69 subscribers
  • Views 886 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 310905
Options

Choice the JTAG, 10 pin

pietrodcs

Good morning

I need the appropriate JTAG for the processor. I am expecting to buy something with a cable fitting the connector in the schematic above.

I hope it is not necessary to arrange hand made strapping to fit the 10 pin on the board.
In a large sense I do not stick to a cheap solution. I need a suggestion to buy the correct JTAG for the nRF processor and the ready to use 
connector.
For example do this work?

I mean is in the package the ready to use cable for the 10 pin connector?

I see also this interesting solution

KITXMCLINKSEGGERV1TOBO1 Infineon Technologies | Utviklingskort, sett, programmerere | DigiKey


Suggest a solution.

Thank You

Pietro

Parents
  • 0

    Hi,

    For example do this work?

    I mean is in the package the ready to use cable for the 10 pin connector?

    The J-link Base is supported by the nRF52 series, however I'm unsure if it contains the breakout board that is necessary to connect to the J-tag header. My J-link base has a breakout board but I'm not 100% sure that it followed the Base or if I bought it separately. You should contact SEGGER and ask them about it,

    regards

    Jared 

Reply
  • 0

    Hi,

    For example do this work?

    I mean is in the package the ready to use cable for the 10 pin connector?

    The J-link Base is supported by the nRF52 series, however I'm unsure if it contains the breakout board that is necessary to connect to the J-tag header. My J-link base has a breakout board but I'm not 100% sure that it followed the Base or if I bought it separately. You should contact SEGGER and ask them about it,

    regards

    Jared 

Children
Related