Choice the JTAG, 10 pin

[pietrodcs]

Good morning

I need the appropriate JTAG for the processor. I am expecting to buy something with a cable fitting the connector in the schematic above.

I hope it is not necessary to arrange hand made strapping to fit the 10 pin on the board.
In a large sense I do not stick to a cheap solution. I need a suggestion to buy the correct JTAG for the nRF processor and the ready to use 
connector.
For example do this work?

I mean is in the package the ready to use cable for the 10 pin connector?

I see also this interesting solution

KITXMCLINKSEGGERV1TOBO1 Infineon Technologies | Utviklingskort, sett, programmerere | DigiKey

Suggest a solution.

Thank You

Pietro

[Jared]

Hi,

For example do this work?

I mean is in the package the ready to use cable for the 10 pin connector?

The J-link Base is supported by the nRF52 series, however I'm unsure if it contains the breakout board that is necessary to connect to the J-tag header. My J-link base has a breakout board but I'm not 100% sure that it followed the Base or if I bought it separately. You should contact SEGGER and ask them about it,

regards

Jared 

[pietrodcs]

Hi Jared

Thank You for coming to me. If You get additional info about the board update here I will read.
What is your opinion about the other solution?

Thank You

Pietro

[Jared]

The base compact? As far as I'm aware It should work as well!

[pietrodcs]

I mean this

Thank You

[Jared]

Hi,

We only support SEGGER programmers officially.

regards