Device not getting detected on VS code

[siddharth7061]

My board nRF 7002 is turned on and connected to my laptop, as you can see it is visible in the library. But it is not getting detected by VS code.

[Johnny Nguyen]

Maybe not exactly the answer to why you're running into it, but I've run something similar if I didn't launch VSCode in admin mode. (Only on specific computers though. Some computers I had _never_ had this as an issue)

Does this still happen if you run VSCode with admin privileges?

[siddharth7061]

actually I'm just a beginner. I am not aware of the admin privileges. I tried following the steps for command line also but I couldn't find the desired directory.

The Link software is able to detect it but not VS code

[Priyanka]

Hi Siddharth,

Could you try setting the default provider in the VSCode extension settings to nrfjprog?

Best Regards,

Priyanka

[siddharth7061]

Hi Priyanka,

Thanks for your suggestion. But I couldn't find the same settings under nrf connect for VScode extension settings, as you can see below.

[Priyanka]

Did you select the extension settings here:

-Priyanka

[siddharth7061]

yes I have tried both ways. first I tried by right clicking it then selecting the settings logo.

[Priyanka]

Have you installed the nRF Command Line Tools, and also the SEGGER J-Link?

-Priyanka