Hello Community!
I have had to purchase an nRF51DK to rewrite firmware for an old PCB. I have been facing some problems in running my development environment (nRF51DK. Bluetooth not working - Nordic Q&A - Nordic DevZone - Nordic DevZone (nordicsemi.com) but I finally have a nice environment.
I have my application with BLE running OK on the nRF51DK, but BLE isn't working on my custom board with nRF51822. I know the application is almost working because I have a blinking LED, but the BLE is not advertising. Some of my discoveries:
1. I flash S130 SoftDevice + my hex with nRF Connect Programmer. It flashes fine.
2. Target configuration in Keil uVision5:
IROM1: Start: 0x1B000, Size: 0x25000
IRAM1: Start: 0x20002080, Size: 0x1F80
3. I am debugging the application with Keil but it stops working (or takes a lot of time) in SOFTDEVICE_HANDLER_INIT(&cic, NULL); where cic is NRF_CLOCK_LFCLKSRC.
If someone can give me some information where I can work on, I would be very thankful.
Regards,
David.