RTT Viewer: Shell and LOG in different terminals

[RadicalTomato]

Hi there,

I understand and I have managed to have both Shell and LOG_ message over RTT (using RTT Viewer). However I am wondering to have the Shell in one Terminal (for example Terminal 0) and  the LOG_ messages in a different terminal (for example Terminal 1)?

I have tried the following:

CONFIG_USE_SEGGER_RTT=y

CONFIG_LOG=y
CONFIG_LOG_BACKEND_RTT=y
CONFIG_LOG_BACKEND_RTT_BUFFER=1
CONFIG_LOG_BACKEND_UART=n

CONFIG_SHELL=y
CONFIG_SHELL_MINIMAL=y
## We will not use USART
CONFIG_SHELL_BACKEND_SERIAL=n
CONFIG_SHELL_BACKENDS=y
CONFIG_SHELL_BACKEND_RTT=y
#CONFIG_SHELL_LOG_BACKEND=n
CONFIG_SHELL_BACKEND_RTT_BUFFER=0

and I get the following output

Any thoughts?

[Naeem Maroof]

Hi Radu Toma,

Is this the same issue like the other case (as it looks like the duplicate)

if so, looks like you found the solution.

[RadicalTomato]

Hello,
No it's not the same with (+) LOG_ (over RTT) and SHELL (over UART2) - Nordic Q&A - Nordic DevZone - Nordic DevZone (nordicsemi.com) . 


This is my initial ticket, where I would like to have an understanding how one can have Shell in one Terminal and the LOG_ messages in a different terminal, over RTT. There is some info in the documentation, and I have tried to configure it, but I believe I am missing something. ( see Shell — Zephyr Project documentation (nRF Connect SDK) (nordicsemi.com) )

This is what I am getting at the moment:

Thank you!

[Naeem Maroof]

Hello,

I have looked into this and the related information.

I was not able to do what you are looking for.

Looks like it is not supported, but you can ask in the zephyr community and ask for feature request.