NRF8001 HARDWARE ERROR

[Martin]

Hello, when the device NRF8001 starts Advertise, it sends out only one packet and unexpectedly terminates with a fatal hardware error in "ll_ctrl.s0.c" line 572. This happens only once after initial setup of the chip. Between device setup and advertise there is as long as 10 seconds gap. The chip is: NRF D 8001 1231EA

Any idea what is the cause of that? Thank you Martin

[run_ar]

Hi Martin,

Unfortunately I don’t know what could cause this. Could you please check that you are not sending any zero byte packets to the nRF8001. Could you also upload the configuration XML and the command sequence you are using so we can see what you are doing?

Thanks,

[run_ar]

Could you also try adding a 10 ms delay from the previous ACI event before you start to advertise?