This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Reset pin behaviour

On both the 51 and the 52, I believe the reset pin is active low, and should otherwise be tied to VDD?

The reason I am asking is that I failed to find this information specifically pointed out in the documentation. If I'm missing something, please point out under which section I could find this in the reference manuals for either of these products.

Thanks a tonne for your time. :)

Parents
  • Hi Fennec and Atune,

    I agree that information about the reset pin is a little bit obscure. But yes, the pin is active low and internal pull up will be enabled if the pin is configured as reset pin (a reset needed after you have configured PSELRESET registers). We will try to improve the documentation.

    For the nRF51, information about the internal pull up for the reset pin can be found at section 11.1 in the nRF51 Reference Manual.

Reply
  • Hi Fennec and Atune,

    I agree that information about the reset pin is a little bit obscure. But yes, the pin is active low and internal pull up will be enabled if the pin is configured as reset pin (a reset needed after you have configured PSELRESET registers). We will try to improve the documentation.

    For the nRF51, information about the internal pull up for the reset pin can be found at section 11.1 in the nRF51 Reference Manual.

Children
Related