Hello,
I want to set the transmitting power of the advertising packet. How can I set the TX power?
I am using nRF Connect SDK 2.5.1 in Visual Studio Code.
Regards,
Sri
Hello,
I want to set the transmitting power of the advertising packet. How can I set the TX power?
I am using nRF Connect SDK 2.5.1 in Visual Studio Code.
Regards,
Sri
Hi
I would suspect that the DCDC is not enabled. Can you share your custom board files(for vscode) and your config files?
Regards
Runar
Hello
I have shared the custom board files and the config files.
Regards,
Sri
Hi
I had a chat with a coworker and showed him the plots. Since your config looks fine, the slope of the current draw may indicate that the matching network/antenna tuning need optimizing.
Regards
Runar
Thank you Runsiv.
I will check the assembly and then tune the matching network for antenna.
Sounds good
It might also be an idea to create a new case where you ask for a hardware review. Then one of our HW engineers will take a look at your design.
You can make a new private ticket and request a review of your board. Please upload both your schematic and layout in form of gerber files in the private case. I would also add that you see issues with the current
Regards
Runar
I have created a new case with ID 328979. Attached my PCB and Schematic files.
Good
I see Ketil has been assigned to the case. Let's wait and see what his feedback is. You could also link the current plots to him
Regards
Runar
Good
I see Ketil has been assigned to the case. Let's wait and see what his feedback is. You could also link the current plots to him
Regards
Runar