52840 Dongle，ble sniffer set coded phy failed

[zadme]

Hello, when testing the BLE sniffer with an nRF52840 dongle (utilizing the most recent official sniffer firmware), I configured Wireshark to capture the coded PHY. After initiating the sniffing process for several seconds and capturing roughly tens of broadcast packets, Wireshark ceases to update data. Upon conducting lower-level debugging, I discovered that the sniffer exclusively outputs counts rather than continuing to output broadcast packets. Could this be attributed to a misconfiguration or are there alternative explanations?

[Edvin]

Hello,

the sniffer exclusively outputs counts rather than continuing to output broadcast packets.

What do you mean by this? What kind of counting are you seeing? 

What sort of packets are transmitted using CODED_PHY? Advertisements, or are you changing over to coded phy after entering a connection?

Best regards,

Edvin

[zadme]

i set this, scan coded phy

flow to thousands of packets and no longer refresh, this phenomenon occurs every time

[Edvin]

Hello,

Sorry for the delay.

I will test tomorrow. But just in case, can you please try to download the sniffer firmware from our source? 

https://www.nordicsemi.com/Products/Development-tools/nRF-Sniffer-for-Bluetooth-LE/Download?lang=en#infotabs

Then we know we are using the same FW.

Also, please try to use the .hex file intended for the dongle, not the DK. And finally, what do you mean by:

zadme said:

I used the SWD burning interface to burn PCA10059

What interface is this? Do you mean the nRF Connect for Desktop -> Programming app?

BR,
Edvin

[zadme]

Hello,

I confirmed that I downloaded the ble sniffer firmware from this link, using a third-party burning tool, and the interfaces are swdio and swdclk on the dongle

Best regards

[PaKa]

The image delivered from Nordic has a hard requirement that the original bootloader is in the Dongle. If you have used SWD interface then it's likely that the bootloader is gone, then the code won't run. Search the forum on how to get the bootloader re-instated, program the sniffer code through the USB interface as described in the user guide and test again.

[zadme]

Received your suggestion, thank you for answering

I will retest the sniffing of the coded phy after correctly burning it

thanks

[zadme]

I have correctly burned open_bootloader_usb_mbr_pca10059_debug.hex and sniffer_nrf52840dongle_nrf52840_4.1.1.hex. Now my usb dongle (pca10059) can be normally recognized by wireshark. Next, let's go back to the initial question. After checking wireshark coded phy option, wireshark will no longer output new packets after sniffing hundreds or thousands of ad packets

thanks