Hi,
I have updated finally Segger Studio from version 7.22 to 8.14. Now I cannot compile the project. It ends with below error:
Build failed, exit status 0x1
Is something needed to make it working?
Hi,
I have updated finally Segger Studio from version 7.22 to 8.14. Now I cannot compile the project. It ends with below error:
Build failed, exit status 0x1
Is something needed to make it working?
Hi
We advice against using newer versions of SEGGER Embedded Studio than what the SDK version you're using have been tested with. nRF5 SDK v17.1.0 was production tested with SES v5.42a, and is the one I would recommend that you use. Some newer versions should be fine as well, but the very latest versions (I don't remember the exact version number) have proved to have some issues, so if your v7.22 works as expected I would recommend using that one on your end, or roll back to v5.42a.
Best regards,
Simon
Hi
We advice against using newer versions of SEGGER Embedded Studio than what the SDK version you're using have been tested with. nRF5 SDK v17.1.0 was production tested with SES v5.42a, and is the one I would recommend that you use. Some newer versions should be fine as well, but the very latest versions (I don't remember the exact version number) have proved to have some issues, so if your v7.22 works as expected I would recommend using that one on your end, or roll back to v5.42a.
Best regards,
Simon