• State Verified Answer
  • Locked Locked
  • Replies 2 replies
  • Subscribers 68 subscribers
  • Views 6187 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 111546
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

flashing to NRF52

kennethlimcp

I have the following:

  • Dev board PCA10040
  • SDK nRF52_SDK_0.9.2_dbc28c9
  • Mac OSx

I was able to compile the blinky example and have the .hex in the _build folder. Pardon me but this is the first time that i am working with a nordic platform.

Copied the .hex file to the JLINK drive and the drive disconnected and reconnected to my Mac. Is this the expected behavior?

I do not see any of the GPIOs toggling and all it does it that the LD5 keeps blinking green when i power it using a usb power supply.

How can i get this blinky example successfully uploaded to my dev board?

Thanks!

Parents
  • 0

    The drag and drop function seems a little unstable with PCA10040 hex files, it seems it only works after a full erase have been done with nrfjprog or nRFgo studio. I suggest you use nrfjprog (a part of nRF command line tools) or nRFgo studio for flashing. You can find them here.

    If LD5 is blinking it may indicate that the programming chip is in bootloader state. Do the disk say "BOOTLOADER"? In that case turn on and off the DK. If you dragged the hex file over while the programming chip was in bootloader state you may want to upload the original bootloader again. See the DK user guide for more.

    EDIT: I noticed that you are using Mac OSx. See this blog or this blog for which tools to use.

Reply
  • 0

    The drag and drop function seems a little unstable with PCA10040 hex files, it seems it only works after a full erase have been done with nrfjprog or nRFgo studio. I suggest you use nrfjprog (a part of nRF command line tools) or nRFgo studio for flashing. You can find them here.

    If LD5 is blinking it may indicate that the programming chip is in bootloader state. Do the disk say "BOOTLOADER"? In that case turn on and off the DK. If you dragged the hex file over while the programming chip was in bootloader state you may want to upload the original bootloader again. See the DK user guide for more.

    EDIT: I noticed that you are using Mac OSx. See this blog or this blog for which tools to use.

Children
No Data
Related