cant program nrf9160 board

[shlomots]

hello, when trying to program my 9160 board, I get this: 

I already tried the recover command but that yielded the same results.
thanks in advance 

-shlomo

[Charlie]

Hi Shlomo,

I have a few suggestions for you to check:

1. Have you tested with other USB cables? Poor-quality cables can sometimes cause issues.
2. Have you tried the same setup with other boards to see if the issue persists?
3. Could you try using nRF Connect for Desktop -> Programmer to program the device?
4. Are you using a custom board or an nRF9160DK?
5. If this is a custom board, have you request hw reveiw for your schematic and PCB layout before?

Please let me know the results so I can assist you further.

Best regards,
Charlie

[shlomots]

First of all, thank for the replay charlie!

Now to your questions:

1. I did

2. Yes i tried it on a dk and it worked.

3. I did, it doesnt work as well, at fails even when all I do is pressing the erase all option.

4. It is a custom board

5. I am not sure exactly what HW review means.

-shlomo