Interface certificate testing. (IPv4 and IPv6)

[meraki]

We are trying to configure our device, which is custom based on nrf7002dk for interface certificate testing.
The requirements for testing are

1. Ensure correct Internet Header Format -  RFC-791, Clause 791
2. IPv4/IPv6 address configuration done correctly when IPv4 and IPv6 enabled simultaneously - RFC 4213 , Clause 2.1
3. Checking the IPv6 header format - RFC 2460/8200, Clause 3
4. Extension header order is maintained - RFC 2460/8200, Clause 4.1
5. The routing header is configured and/or handled properly - RFC 2460/8200, Clause 4.4
6. The Fragmentation  header is configured and/or handled properly - - RFC 2460/8200, Clause 4.5

The testing device needs to connect to our device and check the above, need help with the setup.
Testing device: Alfa AWUS036ACH Wi-Fi adapter. 

[Amanda Hsieh]

Hi, 

To configure and test Wi-Fi functionality, you can use the Wi-Fi Radio test sample or the Wi-Fi Shell sample. These samples allow you to configure and control the Wi-Fi radio on the nRF70 Series device.

1. The Wi-Fi Radio test sample can configure the Wi-Fi radio in specific modes and with various TX and RX parameters. You can find more information about using this sample in the Wi-Fi Radio test sample description.
2. The Wi-Fi: Shell sample allows you to control Wi-Fi functionality through a shell interface. This sample enables the device to connect to a Wi-Fi access point and expose a shell interface through a UART console to run relevant Wi-Fi Shell commands. You can find more details in the Wi-Fi Shell sample documentation.

Regards,
Amanda H.