• State Not Answered
  • Replies 5 replies
  • Subscribers 77 subscribers
  • Views 215 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 343575
Options

nRF54L15: UART pinout not working unless connecting the RTT viewer

Pedro Sousa

Hi everyone,

I am working with the new nRF54L15 and have connected UART21 to pins 2.07-2.08, which are capable of handling both Trace data and UARTE. However, I am encountering an unusual behavior with the UART RXD pin.

When I attempt to use the UART RXD pin, it only works fine when either:

  • The JLINK is connected via SWD
  • The RTT Viewer is connected

If neither of the above tools are connected, I am unable to use the UART RXD at all.

Has anyone else experienced a similar issue with the nRF54L15? Any ideas on what might be causing this behavior or suggestions on how to resolve it would be greatly appreciated.

Thank you in advance for your help!


Parents
  • 0

    P2.07 is connected to the onboard debugger per the DK's schematic.

    Could you try cutting SB24 or disabing the debugger connection in the board configurator?

    docs.nordicsemi.com/.../index.html

  • 0 in reply to khelmutlord


     the only way to make this work seems to     be enabling the debug domain by setting this register to 1:




    If I read the value at startup and it shows or it's set to 0:

    • P2.07 UART RX only works while a JLink Debug session is open. Once the debug session is closed, RX stops functioning.

    If I set the pin value to 1:

    • P2.07 UART RX works consistently, and I can still open and close a JLink Debug session without issues.

    It seems that “acquiring” the GPIO makes the UART21 RX in P2.07 work, but “releasing” it or having it in the default state causes it to fail. Could you help me understand why this might be happening? Is it the intended behaviour?

    Additionally, in a separate ticket my teammate is preparing, we will submit a schematic to Nordic for review. This schematic places P2.07 as the RX pin for a UART to be used in inline production tests (and will remain so in mass production). Given the issue in this ticket, I am not comfortable keeping P2.07 as the RX of the UART. Could you please advise and give feedback based on my observations?

    Thank you in advance!

Reply
  • 0 in reply to khelmutlord


     the only way to make this work seems to     be enabling the debug domain by setting this register to 1:




    If I read the value at startup and it shows or it's set to 0:

    • P2.07 UART RX only works while a JLink Debug session is open. Once the debug session is closed, RX stops functioning.

    If I set the pin value to 1:

    • P2.07 UART RX works consistently, and I can still open and close a JLink Debug session without issues.

    It seems that “acquiring” the GPIO makes the UART21 RX in P2.07 work, but “releasing” it or having it in the default state causes it to fail. Could you help me understand why this might be happening? Is it the intended behaviour?

    Additionally, in a separate ticket my teammate is preparing, we will submit a schematic to Nordic for review. This schematic places P2.07 as the RX pin for a UART to be used in inline production tests (and will remain so in mass production). Given the issue in this ticket, I am not comfortable keeping P2.07 as the RX of the UART. Could you please advise and give feedback based on my observations?

    Thank you in advance!

Children
No Data
Related
Terms of service