DFU issue - bt_mesh_cli: dropping

[Matej]

Dear,

I’m experiencing an issue with performing DFU over BLE Mesh. I have a setup with one node acting as provisioner and distributor. This node has a new image loaded (with a modified advertising name and updated imgtool_sign_version). Additionally, there is one target node (node 3) added in ble mesh. 

I’ve uploaded the image to the distributor, added a slot, and registered the receiver. However, when I start the distribution and check the status, I receive a response indicating phase 10 and status 0.

This setup used to work occasionally when using SDK v2.6.2. However, after migrating to SDK v2.7.0, the issue consistently appears.

Do you have any idea what might be causing this?

Here is Seggers rtt output:

And commands from app:

I have also tried with image index 1, but nothing...

Any idea, inputs?

Thank you 

Best regards,
Matej

[Amanda Hsieh]

Hi, 

Please try NCS v2.9.1.

Regards,
Amanda H.

[Matej]

Hi Amanda,

Thanks for the suggestion. Upgrading to NCS v2.9.1 isn't a trivial task for us at this point. We've already deployed and validated our current setup (NCS v2.7.0) across over 100 nodes in various locations. Repeating the entire validation process would be quite resource-intensive.

Is there any workaround or patch that could address the DFU issue within our existing NCS v2.7.0 setup? If not, any guidance on minimizing the impact of migrating to a newer SDK version would be appreciated.

Best regards,
Matej