NPM1300 Vout

[SkyC]

Hi Sir

The npm1300 allows setting the default voltage using resistor values as shown in the table below. However, if I want to set the voltage to 1.05 V using resistors, is this feasible? Is there a formula available to calculate the corresponding resistor values?

[mathiaso]

Hi, Sky.

It is at least possible to set the output voltage to different values, using register BUCK1NORMVOUT.

However, if I want to set the voltage to 1.05 V using resistors, is this feasible? Is there a formula available to calculate the corresponding resistor values?

I've asked about this internally and will get back to you when I receive an answer.

Best regards,
Mathias