ota error:The image does not have a valid mcu header

[666]

Hi all,

nrf54l15dk,v3.0.1,peripheral_uart demo and no changes have been made.

Then add the following content to prj.conf

sysbuild.conf

mcuboot.conf

Finally, use the OTA file under build to upgrade

Looking forward to your reply！

[Priyanka]

Hi,

Could you take a look at the following and check if it helps?

https://docs.nordicsemi.com/bundle/ncs-latest/page/nrf/app_dev/device_guides/nrf54l/fota_update.html#fota_over_bluetooth_low_energy 

https://devzone.nordicsemi.com/f/nordic-q-a/118439/nrf54l15-fota-2-8-0-sdk-clarification?ReplyFilter=Answers&ReplySortBy=Answers&ReplySortOrder=Descending 

Regards,

Priyanka

[666]

HI

According to the configuration in my question，I can run normally in 2.8.0, but according to the same configuration , the situation shown in the picture will appear in v3.0.1. From the information you provided, I don't see any difference between the two versions. Do you have any suggestions？

Looking forward to your reply！